Creep is calculated as per AS7000.

To visualize the effect of creep, in top menu:

1. Go to Environments

2. For the appropriate environments, tick Apply Creep Offset (specify per conductor)

This will apply any creep specified in the Conductor Properties. If there are more than one conductor set in a span, ensure that a suitable creep as been specified for all the conductor sets in that span.

To specify the creep for a conductor span, left click on the span and then edit the creep offset in the properties pane:

Stringing of a line is a current event, where as creep modelling is a future event. The effect of creep is visualised in the profile view and reported in the sag calculations (Span tab in Conductor Properties). 

Note: Creep will not affect tip load or stringing tables of new lines.