Stay editor can be accessed via:
selecting the stay within the work space
in Overview Limit State Table tab by clicking on the Stay name in column 3
The stay editor is only shown if exactly one stay is ticked. It is there purely as a convenience to allow some stay properties to be edited within the tip load section when assessing tip load capacity of poles.
Stays can also be edited directly by clicking on them in the workspace.
(4) Stay Cable Type + Stay Type
Stay cable type and style type can be changed here.
- Side Walk Stay
- Ground Stay (default)
Figure 1 - Side Walk Stay
Figure 2 - Ground Stay
(5) Distance from Top
Stay's attachment distance from pole top.
(6) Offset Distance
Distance between pole at ground and stay at ground.
The angle of the stay at ground to north, relative to the pole.
Figure 3 - Bearing angle
(8) Attach Height
Stay's attachment distance from ground.
(9) Top Angle
Angle between stay and pole.